Why do I get error Bad Username
m |
m |
||
| Line 2: | Line 2: | ||
| - | If you have been directed to this page when trying to connect to DareNET, then chances are you're also receiving the following error message: '''Bad username'''. You're NOT banned! This is in reference to the User ID (sometimes known as username or ident) that is between ! and @ in your hostmask (i.e. nick!user@host). | + | If you have been directed to this page when trying to connect to DareNET, then chances are you're also receiving the following error message: '''USER: Bad username'''. You're NOT banned! This is in reference to the User ID (sometimes known as username or ident) that is between ! and @ in your hostmask (i.e. nick!user@host). |
All User ID's must comply with a few specific rules, which are shown below: | All User ID's must comply with a few specific rules, which are shown below: | ||
Revision as of 03:02, 30 May 2009
|
| NOTE: This error does NOT mean you have been banned from the network! |
If you have been directed to this page when trying to connect to DareNET, then chances are you're also receiving the following error message: USER: Bad username. You're NOT banned! This is in reference to the User ID (sometimes known as username or ident) that is between ! and @ in your hostmask (i.e. nick!user@host).
All User ID's must comply with a few specific rules, which are shown below:
- Only one '-', '_' or '.' is allowed. Two are allowed, if not consecutive, but not as the first or last character.
- No other special characters are allowed.
- Must contain at least one letter.
- If using upper and lower case letters, the first letter must be upper case, and may contain one other upper case letter anywhere.
- A third upper case letter may be used if all three appear at the beginning (only separated by '-', '_' or '.')
Change your User ID to comply with the above rules, and try reconnecting!
mIRC users
To change your User ID, follow these steps:
- Go to Options (hit Alt+O) > Email Address (your User ID is the part before the @)
- Go to Options (hit Alt+O) > Select Connect > Select Ident (enter your User ID)
- Press OK. You should now be good to go!
